Lage verzendkosten vanaf
EAN: 8720618489500
Nano V3 Arduino Compatible CH340 Red (OT5821)
Show all:
Microcontrollers,
Lage verzendkosten vanaf
30 dagen bedenktijd
1 jaar garantie
Description
An Arduino Nano clone. Works just as well but is a lot cheaper. Please note, the headers are supplied separately and you must solder them yourself.
Microcontroller Atmel ATmega168PA Working voltage (logic level): 5VDC Input voltage (recommended): 7V ~ 9VDC Input Voltage (limit): 6V ~ 12 VDC Digital I/O Pins: 14 (of which 6 provide PWM output) Analog Input Pins: 8 DC voltage per I/O Pin: 40m AFlash Memory: 16KB (ATmega168) (of which 2 KB used by bootloader) SRAM: 1KB (ATmega168) EEPROM: 512B (ATmega168) Clock speed: 20MHz The Arduino Nano V3 is supplied without a USB cable and is not assembled.
If you use this Arduino "old bootloader" under tools->processor.
This Arduino Nano clone works exactly the same as the original Arduino Nano and can be programmed with the Arduino IDE software. This is available for Windows, Mac and Linux.
Download Arduino IDE
NOTE: This Arduino Clone is based on the CH340 USB chip. Sometimes it is necessary to install the driver for this for Windows or Mac. For Linux this is actually rarely the case.
First try if it works without installing the driver. If there is a COM port available in the Arduino IDE that you can upload to, then it is all set and nothing needs to be installed.
If necessary, you can download the required driver here:
Download CH340 driver for Windows
Download CH340 driver for Mac
Download CH340 driver for Linux
Disclaimer: Downloading and installing the offered drivers is an additional service from us and entirely at your own risk. We cannot guarantee that the offered drivers are up-to-date. Any malfunctions that arise from the use of these drivers are at the risk of the person who installs the drivers.
DimensionsLength: 4.5cmWidth: 1.75cmHeight: 0.5cm
Read moreRead lessMicrocontroller Atmel ATmega168PA Working voltage (logic level): 5VDC Input voltage (recommended): 7V ~ 9VDC Input Voltage (limit): 6V ~ 12 VDC Digital I/O Pins: 14 (of which 6 provide PWM output) Analog Input Pins: 8 DC voltage per I/O Pin: 40m AFlash Memory: 16KB (ATmega168) (of which 2 KB used by bootloader) SRAM: 1KB (ATmega168) EEPROM: 512B (ATmega168) Clock speed: 20MHz The Arduino Nano V3 is supplied without a USB cable and is not assembled.
If you use this Arduino "old bootloader" under tools->processor.
This Arduino Nano clone works exactly the same as the original Arduino Nano and can be programmed with the Arduino IDE software. This is available for Windows, Mac and Linux.
Download Arduino IDE
NOTE: This Arduino Clone is based on the CH340 USB chip. Sometimes it is necessary to install the driver for this for Windows or Mac. For Linux this is actually rarely the case.
First try if it works without installing the driver. If there is a COM port available in the Arduino IDE that you can upload to, then it is all set and nothing needs to be installed.
If necessary, you can download the required driver here:
Download CH340 driver for Windows
Download CH340 driver for Mac
Download CH340 driver for Linux
Disclaimer: Downloading and installing the offered drivers is an additional service from us and entirely at your own risk. We cannot guarantee that the offered drivers are up-to-date. Any malfunctions that arise from the use of these drivers are at the risk of the person who installs the drivers.
DimensionsLength: 4.5cmWidth: 1.75cmHeight: 0.5cm
Eerder bekeken
Ook interessant voor u: